- Cotton Rope
- Know your knots
This is a very simple hack and I use it when I put my phone calls on speaker mode. I simply tied two ropes around my car visor where it was tight enough to carry the weight of my cell phone. The ropes still don’t interfere with my visor mirror use as well.
The rope loop on the left side of my visor was tied as it was placed on my visor, then tied off. The rope loop on the right side was actually measured by gauging how much rope I needed to wrap around the visor and then I tied a knot to close off that piece. I slid it over the visor and because it was a tight squeeze, I knew the knot would naturally tighten more as I was trying to stretch the rope accordingly. I wanted this lop to be tight because it would carry more weight compared to the other one.
The right rope loops is tight enough to hold my cell phone in place in a vertical position. Sometimes I’ll write down my directions if I know I’m going somewhere, where I know I won’t get good reception and place the paper behind the left rope loop. These are good for lists too (ie. grocery lists, errand stop offs, to-do lists, etc).
If I’m driving long distances and I need to swing my visor out to block out the sun from the driver’s side window, I’ll usually slide the phone in on the other side of the visor. It will still hold it in place and technically, the microphone will be even closer to hear and speak into. If you do use this method, just remember to not swing the visor too aggressively. If you do need to use your visor for a short time, keep in mind which side of the visor your phone is on.
So there you have it, my very simple car hack for cell phone speaker mode.
Please don’t text while driving.
One thought on “Car Hack For Cell Phone Calls”
What a great idea and no cost!
LikeLiked by 1 person