DIY Thumb Loops In Sweater Sleeves

11.18.2019

0600

So this blog post is a personal life hack of mine. When I work out, I like to wear sweaters. Now, these sweaters are not always athletic sweaters, but simple sweaters that I buy just to wear on a day-to-day basis. I like to go running in these sweaters because they’re comfortable and warm. However, when I go running with these sweaters, the sleeves tend to run up my arm. I prefer the sweaters to cover my wrist and not bunch up when I’m running. I like the running sweaters that are designed with thumb loops, but they tend to be more expensive as well. Since I love my sweaters that I wear day to day, I decided to create my own thumb loops for my sweaters.

It’s a very simple process to create these thumb loops. First, I laid down my sweater where the sleeve lay flat on the table. I located the center line of the sleeve, and then chose to locate my thumb loop on the bottom half of the sleeve, but on the cuff of the sleeve. I found the center line of the bottom half of the sleeve, and I decided to locate my new thumb loop there.

When I wear my sweaters, my hand falls naturally to my side, in which my thumb faces towards the front of my body. This is why I located the thumb loop on the bottom half of the sleeve.

I wanted my thumb loop to be 1 inch in length and about half an inch from the bottom of the sleeve cuff. Using scissors, I cut a small slit that was 1 inch in length.

For my right sleeve, I used the same process as I did with the left sleeve. I located the center line of the right sleeve, and then located the center of the bottom half of the sleeve. I cut a one inch slit that was half an inch away from the bottom of the sleeve cuff.

I removed my extension table in order for the sleeve to fit underneath the presser foot of the machine. I slid the left cuff over the needle plate and started to sew the edge of the thumb loop. I used a tight zigzag stitch, so the fabric would hold up during washes and use. Since I knew that these thumb loops would go through a bit of wear and tear, I used the back stitch lever to create a strong and permanent attachment at the ends of the thumb loops.

The back stitch lever created the heavy and thicker starting points and end points of the outline of the thumb loops.

I flipped my left sleeve inside out, and continued to outline the other side of this thumb loop. I used the zigzag stitch again and used the back stitch lever so both ends of the opening would have an even reinforcement, of the thumb loop.

When I turned my sweater inside out, the thumb loops were finally finished being created. I use this hack on both of my sweaters, so now the sleeves won’t run up my arms when I workout.

This is a really simple hack for an issue that I dealt with on a daily basis. Although I know my thumbs will stick outside of my sleeves, when I run,they don’t get too cold. Sometimes I will run with my running gloves when the weather drops too low, so technically, my hands are still warm. Some people prefer to not have the thumb loops, but I like to keep my wrists covered when I run. This hack took less than 30 minutes to create and finish, so it didn’t take much time out of my day at all. I hope this hack will inspire other hacks that you might be needing in your life.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s