06.20.2017

0600

Materials:

1. One sheet of brown peg board
2. KOMPLEMENT drawer handles from IKEA
3. Bulk rope from Jo-Ann Fabric and Craft Store
4. Extra nuts and bolts to secure the handles to the peg boards

 

Drawers:

I first had to measure the width of my cabinet openings, due to the fact that they were old up-cycled cabinets from when we had first moved into this house. The cabinet drawer opening measured 12″ wide and 24″ deep. Ideally, most new cabinet installments would add a nice overall look and clean up the space a bit, but the way new sliding drawers are built, the thickness of the wood would eat up a lot of the width opening. This is why I decided to make some generic sliding drawers.

I measured out the dimensions of 11-1/2″ wide and 20″deep on the peg board, and I had just enough board to make up three drawers. Because the peg board came with pre-drilled holes, it was easy to guesstimate where the handles would be located, and not all of the handles would necessarily be centered. Also, the screws that came with the handles accessories package were designed to fit a 3/4″ thick board, but the peg board was only 1/4″ thick. this is why I had to gather a few extra nuts to infill the space between the original handle screw and the end of the handle itself.

Once I cut the boards to the right size to fit the openings, I placed the handles where I wanted them to be located and attached the nuts and screws accordingly. Because I wanted these drawers to slide, I went to a local fabric store and bought some thick bulk rope. I used this rope to wrap around the long sides of the drawers so that they would slide out easier. The rope also evidently contained the items sitting on top. You can also contain the items that would sit on top of these drawers by screwing a thin piece of wood onto the top of the drawer so  you have a more secure way of holding your items.

Because the motion of the drawers is more of a pull-out motion when in use, I was more concerned about the items falling off in the back of the drawer when the drawer was pulled outward. Once the rope was tied on, I placed my items inside my small rectangular, fabric containers.

 

Drawer Guides:

I nailed down 12″(L) x 1/4″(W) x 3/4″(D) wooden pieces on each side of the drawers, inside the cabinet, as guides for the drawers. I chose to use a 12″(L) because the depth of the cabinet is 24″. I braced the guides up against the front of the cabinet, in which these guides will help slide out the drawers along a smoother line.

Conclusion:

These drawers are very simple sliding drawers made form material found around the house. There are a number of designs to secure drawer guides in place, and this one was a very simple design. If I had used a 1/4″ bottom for the drawers, I would have secured a different drawer guide design underneath the drawer. I genuinely like the fact that these drawers slide on the rope and it makes virtually no sound when pulled out and pushed back in. It doesn’t’ scratch the surface of the cabinet shelves and it’s simple enough to take apart if I no longer have the need for this design. Maybe this design will work for you, in other areas of your home. I hope this post might have helped brainstorm some ideas.